Fixtures
Toilet, faucet, and disposal repair in Matthews, NC
A toilet that runs all night, a faucet that drips no matter how tight you turn it, or a disposal that hums but won't turn, these are the small jobs that turn into a bigger water bill if they wait too long.
Repair versus replace, and how we decide
A running toilet is almost always a cheap part, a flapper or fill valve, and rarely worth replacing the whole toilet over. A cracked tank, a flange that's broken below the floor, or a disposal old enough that parts aren't available anymore is a different story, and we'll say so rather than nickel-and-dime a repair on something that's going to need replacing again in a year anyway.
Faucets are similar. A cartridge or valve replacement handles most drips, but a faucet body that's corroded through, common on original fixtures in homes going back to the 1980s and 1990s around Matthews and Pineville, usually means the fixture itself needs replacing. Common cartridges and flappers ride on the truck, so a lot of this gets fixed the same visit.
What we handle under fixture repair
- Running or phantom-flushing toilets, usually a worn flapper, fill valve, or flush valve
- Toilets rocking on the floor or leaking at the base, often a failed wax ring or a cracked flange
- Dripping or low-pressure faucets, kitchen and bath, cartridge and compression style both
- Garbage disposals that hum without turning, jam, or leak at the sink flange
- Shower valve repair and replacement, including older two-handle setups being converted to a single control
- Outdoor hose bib repair, common in older homes where a freeze has cracked the fitting
What drives the price
| Part availability | A standard flapper or cartridge is a fast fix; a discontinued faucet or older toilet model can mean sourcing a specific part or replacing the fixture. |
|---|---|
| What's underneath | A toilet leaking at the base can mean a simple wax ring swap or a cracked flange needing subfloor repair, which changes the job significantly. |
| Access to shutoffs | Old or seized shutoff valves sometimes need replacing before a fixture repair can even happen safely. |
| Disposal age and mounting | A disposal jammed or leaking at the flange is usually a quick fix; one with a burned-out motor gets replaced, not repaired. |
How a fixture visit goes
- Diagnose on the spotToilet tank open, faucet handle pulled, or disposal checked under the sink before anything's assumed.
- Price before the workRepair or replacement, whichever applies, explained and priced before parts come out of the truck.
- Fix or swapCommon parts are on the truck; if a specific fixture needs sourcing, we'll say so and give a realistic timeline.
- Test under real useToilet flushed several times, faucet run hot and cold, disposal run with water, before we call it done.
Questions we get on the phone
My toilet runs every so often even when no one's used it. What's wrong?
That's almost always a worn flapper or fill valve letting water slowly leak from the tank into the bowl, which then triggers a refill. It's a cheap, fast repair, and it's worth fixing since it can waste a meaningful amount of water running unnoticed for months.
Is it worth repairing an old faucet or should I just replace it?
If the body of the faucet is sound and it's just dripping, a new cartridge or valve usually solves it for less than a full replacement. If the faucet itself is corroded or the finish is failing, replacement is usually the better use of the visit, and we'll tell you which applies once it's apart.
Why does my garbage disposal hum but not spin?
That's usually a jam, something lodged against the impeller, and it can often be cleared with the reset button and a hex key turn from underneath. If it hums with no spin even after clearing a jam, the motor itself may have failed and the unit needs replacing.
How much does toilet or faucet repair cost?
It depends on the part needed and what's found once it's opened up. A standard flapper is a small job; a cracked flange under a toilet is bigger. The plumber diagnoses on site and tells you what the repair costs before starting, so you can decide between a repair and a new fixture.